SolveCalculator All solvers

Data

Standard deviation for students

A student looking into a microscope at a lab table
Photo: Мирослава Тимофіїв, CC BY 4.0, via Wikimedia Commons

In a science practical, five groups measure the same thing and get five slightly different answers. That is normal: hands shake, stopwatches start late, eyes read scales differently. Standard deviation is how scientists describe that wobble with a single number.

Average is not enough

Imagine two groups timing a pendulum swing, five times each.

  • Group A: 1.98, 2.00, 2.01, 2.00, 2.01 seconds
  • Group B: 1.70, 2.30, 1.90, 2.20, 1.90 seconds

Both groups have a mean of exactly 2.00 seconds. But Group A clearly measured more consistently. The standard deviation shows it: about 0.01 s for Group A and about 0.25 s for Group B.

Calculating it by hand

Use the small data set 4, 8, 6, 2.

  1. Mean: (4 + 8 + 6 + 2) ÷ 4 = 5.
  2. Distances from the mean: -1, 3, 1, -3.
  3. Square them: 1, 9, 1, 9. Squaring stops the negatives cancelling the positives.
  4. Add: 20.
  5. Divide: by n = 4 for a population (5), or by n - 1 = 3 for a sample (6.67). This is the variance.
  6. Square root: √5 ≈ 2.24 (population) or √6.67 ≈ 2.58 (sample).

Sample or population?

If your numbers are everything you care about, use population. If they are a few measurements standing in for a bigger picture, which is nearly always the case in experiments and surveys, use sample. Dividing by n - 1 makes the answer slightly bigger, a built-in allowance for the fact that a small sample tends to underestimate the true spread.

Using standard deviation

  • Spotting outliers: a result more than two standard deviations from the mean is unusual and worth rechecking.
  • Comparing reliability: a smaller standard deviation means more repeatable measurements.
  • The 68-95-99.7 rule: for bell-shaped data, about 68% of values fall within one standard deviation of the mean, 95% within two, and 99.7% within three.

Writing it in a lab report

Report the mean with its standard deviation and the same number of decimal places: "2.00 ± 0.25 s (mean ± SD, n = 5)". That one line tells the reader both your best value and how much to trust it.

More study notes